Add Liquidity (V2)
Last updated
Last updated
From the “Swap” section, locate and click the orange “V2 Add Liquidity” button.
For adding liquidity, select the “LP only” mode.
Select the tokens you would like to bundle into the LP and the amount. In the above example, METIS and m.USDC are used as the first and second tokens (0.01 METIS and 0.485415 m.USDC, or ~$0.98 of METIS-m.USDC liquidity is provided.)
Below, you may view additional information such as the swap rates and liquidity ratios between the two selected tokens. Once confirmed, approve the amount to add liquidity by clicking the orange button below (Approve m.USDC” is shown in this example.)
After clicking the “Approve” button from the previous step, Your Web3 wallet will prompt you to approve the transaction. Review all the details, then click approve.
(You may also enter a custom spending cap. In this example, the custom spending cap request is for m.USDC. Note: this will allow the third party to spend the entire token balance until it reaches the cap.)